VM failed to start with Event ID 12140, 12010, 12030
we running vms on windows 2008. when trying start 1 of vms, get the failed start message event id 12140, 12010 , 12030
log name: microsoft-windows-hyper-v-worker-admin
source: microsoft-windows-hyper-v-worker
event id: 12140
task category: none
level: error
description:
description event id 12140 source microsoft-windows-hyper-v-worker cannot found. either component raises event not installed on local computer or installation corrupted. can install or repair component on local computer.
if event originated on computer, display information had saved event.
the following information included event:
autodesk
808419ff-6855-4db9-8dd4-dbb30567b6e9
e:
%%2147942432
0x80070020
ide/atapi
1/0
the locale specific resource desired message not present
log name: microsoft-windows-hyper-v-worker-admin
source: microsoft-windows-hyper-v-worker
date: 9/12/2011 1:47:37 pm
event id: 12010
task category: none
level: error
description:
description event id 12010 source microsoft-windows-hyper-v-worker cannot found. either component raises event not installed on local computer or installation corrupted. can install or repair component on local computer.
if event originated on computer, display information had saved event.
the following information included event:
autodesk
808419ff-6855-4db9-8dd4-dbb30567b6e9
microsoft emulated ide controller
%%2147942432
0x80070020
{83f8638b-8dca-4152-9eda-2ca8b33039b4}
the locale specific resource desired message not present
log name: microsoft-windows-hyper-v-worker-admin
source: microsoft-windows-hyper-v-worker
date: 9/12/2011 1:50:42 pm
event id: 12030
task category: none
level: error
description:
'autodesk' failed start. (virtual machine 808419ff-6855-4db9-8dd4-dbb30567b6e9)
any help?
bob lin, mvp, mcse & cne networking, internet, routing, vpn troubleshooting on how setup windows, network, vpn & remote access on
hi,
in order perform further research, please me collect following information:
1. what’s operating system within problematic vm?
2. how many cpu , memory did assign vm?
3. did have anti-virus software installed on hyper-v host machine?
by way, can check following link see whether can resolve issue.
http://www.chicagotech.net/netforums/viewtopic.php?f=3&t=5699
important note: response contains reference third party world wide web site. microsoft providing information convenience you. microsoft not control these sites , has not tested software or information found on these sites; therefore, microsoft cannot make representations regarding quality, safety, or suitability of software or information found there. there inherent dangers in use of software found on internet, , microsoft cautions make sure understand risk before retrieving software internet.
vincent hu
Windows Server > Hyper-V
My problem was caused by a SCSI interface that somehow got added to the VM. There was no drive(VHD) attached to the interface so I removed it. Once it was removed my VM booted normally. My running theory is during the backup process it may add the SCSI interface to help the back up process and when I interrupted it to bring back my VM's it didn't get the chance to clean up after itself leaving the useless interface to screw up my startup.
ReplyDelete